Setting Device Control Parameters (Set); Reset To Factory Settings - Bender ISOMETER isoGEN423 Manual

Display
t
ton
toff
test OFF/1/24
FAC Factory settings
Cs Customer settings
4.7

Setting device control parameters (SEt)

Open menu 'SEt' to configure the device control.
Display Activation
FAC
off
GEn
dc
nEt on
S.Ct on
FAC
SYS
FAC Factory settings
Cs Customer settings
4.8

Reset to factory settings

All settings with the exception of the interface parameters are reset to the factory settings.
1. Press MENU button (> 1.5 s).
2. Go to 'SEt' and confirm with Enter.
3. Go to 'FAC' and confirm with Enter.
Setting value
Range FAC
0...10 0
0...99 0
0...99 0
24
Cs Range
0. . .999
GEn
dc
Cs
s Start-up delay when starting the device
s Response delay K1 and K2
s Delay on release K1 and K2
h Repetition time for device test
Setting value
FAC Cs
0
GEn
ISOMETER® isoGEN423
Description
Description
Password for parameter setting
Selection of the system to be monitored
GEn: generators (AC, AC with connected DC,
DC )
dc: DC system
Test of the system connection during device
test
Device test during device start
Restore factory settings
For Bender Service only
isoGEN423_D00221_05_M_XXEN 25