Deleting Transmitters; Overwriting The Master - Becker P4-30 Assembly And Operating Instructions Manual

Deleting transmitters

Deleting individual transmitters
The programmed master transmitter cannot be deleted. It can only be overwritten (see
Programming the master transmitter [} 13]).
Deleting all transmitters (except the master transmitter)

Overwriting the master

There are two ways to overwrite the master:
• Readying the tubular drive for programming by switching on the power
• Readying the tubular drive for programming with the radio switch
Readying the tubular drive for programming by switching on the power
To ensure that the new master transmitter is programmed in the desired tubular drive only,
all other tubular drives which are connected to the same power supply must be deactivated
from the programming mode. To do so, after switching back on the power, execute a drive
or stop command using the transmitter for the given tubular drives or switch the radio
switch from inside to outside. If the radio switch is already in this position, switch it to the
inside and back to the outside position.
Press the programming button on the master transmitter for 3 seconds.
▻ The tubular drive acknowledges.
Now press the programming button of the transmitter to be deleted for 3 seconds.
▻ The tubular drive acknowledges.
Then press the programming button of the transmitter to be deleted again for 10
seconds.
▻ The tubular drive acknowledges.
► The transmitter is now deleted from the tubular drive.
Press the programming button on the master transmitter for 3 seconds.
▻ The tubular drive acknowledges.
Re-press the programming button on the master transmitter for 3 seconds.
▻ The tubular drive acknowledges.
Re-press the programming button on the master transmitter for 10 seconds.
▻ The tubular drive acknowledges.
► All transmitters (except the master transmitter) are now deleted from the re-
ceiver.
17