Assembling And Disassembling The Drive Adapter With Separate Drive Adapter Safety Catch; Assembling And Disassembling The Drive Adapter With Screw Connection; Mounting The Drive In The Tube - Becker P4-30 Assembly And Operating Instructions Manual

Assembling and disassembling the drive adapter with separate drive adapter safety catch

Assembling and disassembling the drive adapter with screw connection

Mounting the drive in the tube

Y
X
Size of drive
[mm]
dia. 35-dia. 45
dia. 58
dia. 58
We also recommend screwing the idler to the barrel.
10
For profile tubes:
In the case of some drive adapters, tolerances of the groove widths in different bar-
rels can be offset by rotating the drive adapter into a different groove recess. These
groove recesses have different sizes and allow the drive to fit exactly.
For round shafts:
Measure the lug of the thrust ring (X, Y). Then notch the tube on the motor side, so
the lug of the thrust ring can also be pushed into the shaft. There must be no play
between the lug of the thrust ring and the shaft.
To ensure secure torque transmission for round shafts, we recommend screwing the
drive adapter to the shaft (see the table below).
Attention! When drilling into the barrel, never drill near the tubular drive!
-10 mm
Drive adapter
All
Aluminium drive adapter
diecast drive adapter
Torque
max. [Nm]
Up to 50
Up to 120
Up to 120
Fastening screws
(4 units)
Self-tapping screw
dia. 4.8 x 9.5 mm
Countersunk screw
M8 x 16 mm
Self-tapping screw
dia. 6.3 x 13 mm