Intermediate Positions I + Ii; Programming Additional Transmitters - Becker P4-30 Assembly And Operating Instructions Manual

Intermediate positions I + II

The intermediate positions I + II are freely selectable positions for the shading solution
between the two limit positions. Each travel button can be assigned one intermediate posi-
tion. Both limit positions must be set before an intermediate position is set.
Setting the desired intermediate position
Travelling to the desired intermediate position
Deleting the desired intermediate position

Programming additional transmitters

In addition to the master transmitter, up to 15 further transmitters can be programmed in
the tubular drive.
16
Open/close the shading solution to the desired intermediate position.
Press the STOP button and, within 3 seconds, also press the desired travel button
and hold the two buttons down.
▻ The tubular drive acknowledges.
► The intermediate position is now saved.
Press the travel button for the desired intermediate position twice within one second.
► The curtain runs to the intermediate position assigned to the travel button.
Move the shading solution to the intermediate position that is to be deleted.
Now press the STOP button and, within 3 seconds, also press the travel button as-
signed to the intermediate position and hold the two buttons down.
▻ The tubular drive acknowledges.
► The intermediate position is now deleted.
Press the programming button of the master transmitter for 3 seconds.
▻ The tubular drive acknowledges.
Now press the programming button of a new transmitter which has not yet been pro-
grammed in the tubular drive for 3 seconds. Doing so activates the programming
mode of the tubular drive for a new transmitter for 3 minutes.
▻ The tubular drive acknowledges.
Now press the programming button of the new transmitter you wish to program again
for 3 seconds.
▻ The tubular drive acknowledges.
► The new transmitter has now been programmed.