Table of Contents
Advertisement
2.9
Power Connections
Power is connected to the power supply and the CPU board through the power harness.
2.9.1
380-2D Power Connections
The 380 Synergy Indicator is powered by 4 C-Cell Batteries or an optional 12 V adapter (PN 206433). When the adapter is
inserted into the power jack, indicator power is disconnected from the battery holders and batteries no longer drain. The Power
adapter does not charge the batteries.
NOTE: Optional power adapter (PN 206433) is the only external power source allowed to be used.
NOTE: Ensure that battery covers are screwed finger tight. If covers are not fully screwed on, the indicator will not function.
Connector
Pin
CN1
1
2
3
4
Table 2-8. CN1 Alkaline Battery Pin Assignments (Power Supply)
Black wire to GND
Black Jumper Wire
Red wire to CN1
Pin 1
Table 2-8
Figure 2-12. 380-2D Battery Cell Wiring
© Rice Lake Weighing Systems ● All Rights Reserved
Wire
Power
Red
+Vin
Black
GND
N/A
N/A
N/A
N/A
Red Wire to Pin
Black wire to CN1
Pin 2
Table 2-8
Installation
17
Advertisement
Table of Contents
Need help?
Do you have a question about the Revolution Synergy Series and is the answer not in the manual?
Questions and answers