Siemens SIMATIC ET 200eco PN M12-L Equipment Manual page 31

PROFINET IO
5.1 Parameters/address space
Input delay
This parameter can be used to suppress signal interference. Changes to the signal are only
detected if they are present consistently for longer than the set input delay time.
For input channels with longer input delays, the read-in time is moved accordingly. This
means individual channels can be assigned input delays, if necessary, without having a
negative impact on the possible cycle time.
Hardware interrupt on rising edge (only for DIQ)
Specifies whether a hardware interrupt is generated for a rising edge on the channel.
Hardware interrupt on falling edge (only for DIQ)
Specifies whether a hardware interrupt is generated for a falling edge on the channel.
Configuration mode (only for DIQ)
Specifies whether the channel operates as digital input (DI) or digital output (DQ).
Reaction to CPU STOP (only for DIQ)
With this parameter, you set the reaction of the digital outputs of the I/O device after a CPU
STOP:
• Shutdown: The digital output is de-energized.
• Keep last value: The last value of the digital output remains activated.
• Output substitute value 1: The I/O device outputs the substitute value "1".
Port configuration without S7-PCT
This parameter releases the port configuration without S7-PCT for the module.
Note
Changes to the port configuration
If you have assigned the IO-Link device parameters via port configuration without S7-PCT, or
have configured the port as a digital input, digital output or deactivated, you can no longer
change the port configuration via S7-PCT.
30
CM 8x IO-Link + DIQ 8x24VDC M12-L 8xM12 (6ES7148-6JJ00-0BB0) communications module
Equipment Manual, 12/2022, A5E51718265-AB