Explanation Of The Parameters - Siemens SIMATIC ET 200eco PN M12-L Equipment Manual

7.1.3

Explanation of the parameters

Diagnostics: Undervoltage 1L+
Enabling of the diagnostics for insufficient supply voltage 1L+.
Diagnostics port
This parameter enables the diagnostics for the selected IO-Link port.
In the diagnostics A distinction is made between error and maintenance interrupts. The
possible diagnostics are dependent on the IO-Link device used. More information about the
diagnostic interrupts can be found in the description of the utilized IO-Link device.
Hardware interrupt (device notification)
Enable of the hardware interrupt for the selected IO-Link port.
The possible hardware interrupts are dependent on the IO-Link device used. More
information on the hardware interrupts can be found in the description of the IO-Link device
used.
Note
Configuration as digital input or digital output
Note that you cannot enable any port parameters or diagnostics alarms in SIO mode.
Diagnostics: Short-circuit
Enable diagnostics:
• On short-circuit of the encoder supply to ground.
• On short-circuit of the output to ground.
• On short-circuit of the output to 1L+.
Diagnostics: Wire break detection and alarm
Activates wire break detection and enabling of diagnostics for the digital input. In the event
of an interruption of the cable between the encoder and I/O device, a diagnostics alarm is
generated.
Note
• This diagnostics is only available for channels configured as inputs.
• Influence on the value status:
If the parameter is deactivated, wire break detection is switched off. A wire break does not
have an effect on the value status.
CM 8x IO-Link + DIQ 8x24VDC M12-L 8xM12 (6ES7148-6JJ00-0BB0) communications module
Equipment Manual, 12/2022, A5E51718265-AB
7.1 Functions/parameters/address space
Modbus TCP
65