Explanation Of The Parameters - Siemens SIMATIC ET 200SP Manual

4.3

Explanation of the parameters

Diagnostics no supply voltage L+
Enabling of the diagnostics for no or insufficient supply voltage L+.
Diagnostics: Short-circuit
Enabling of the diagnostics when a short-circuit of the actuator supply occurs.
Diagnostics overflow
Enabling of the diagnostics when the output value exceeds the overrange.
Diagnostics underflow
Enabling of the diagnostics when the output value exceeds the overrange, falls below the
minimum output value or reaches underflow.
Diagnostics wire break
Enabling of the diagnostics if the line to the actuator is broken.
Output type / output range
See section Output ranges (Page 16)
Reaction to CPU STOP
Determines the behavior of the module at CPU STOP.
Substitute value
The substitute value is the value that the module outputs in case of a CPU STOP.
Potential group
Specifies that a BaseUnit with voltage supply feed-in is located in this slot (see system
manual ET 200SP Distributed I/O System
(http://support.automation.siemens.com/WW/view/en/58649293)).
Analog Output Module AQ 4xU/I ST (6ES7135-6HD00-0BA1)
Manual, 03/2016, A5E03573365-AD
Parameters/address space
4.3 Explanation of the parameters
19