Epson SC-F2200 Series User Manual page 58

SC-F2200 Series User's Guide
F
Press Done, and then press Start on the next
screen.
The platen is pulled into the printer.
If one of the following messages is displayed on
the control panel screen, you need to change
the combination of spacers.
❏ The position of the media surface is too
high.
❏ Cannot move the movable base.
See the following table to change the
combination of spacers, and then start
adjusting again from the beginning.
"Attaching and Removing Spacers" on
page 59
When using the hanger platen or the standard
platen
*
Media thickness
6 mm to 12 mm
(0.24 to 0.47in.)
12 mm to 16 mm
(0.47 to 0.63in.)
16 mm to 24 mm
(0.63 to 0.94in.)
* When using a platen without a grip pad, 1 mm
(0.04in.) thicker than the values stated in the table
is acceptable.
When using the sleeve platen or the medium
grooved platen
Media thickness
7 mm to 14 mm
(0.28 to 0.55in.)
If you cannot perform adjustments even after
changing the combination of spacers, measure
the media thickness and see the following.
"Image quality is not stable even when
printing under the same conditions / The
position of the media surface is too high.
is displayed even when printing on the same
media / Platen Height Adjustment is not
performed successfully" on page 125
Basic Printing
Spacers
Attach to A only
Attach to B only
Remove all
Spacers
Remove all
58
G
Move the lever to the left by one notch on
the scale to locate the position where the error
sounds (a beep is heard) and The position of
the media surface is too high. is displayed on
the screen.
H
Move the lever one notch to the right to locate
the position where the error sound stops.
I
Press OK, and then press Done on the next
screen.
J
Tighten the fixing lever, and then secure the
platen gap lever.