To Test The Time Measurement Accuracy (Oscilloscope); Set Up The Equipment - HP 1660 Series Service Manual

To test the time measurement accuracy (oscilloscope)

Testing the time measurement accuracy verifies the performance of the following
specification:
•
Time Measurement accuracy
This test uses a precise frequency source to check the accuracy of time
measurement functions.
Equipment Required
Equipment Critical Specifications
Signal Generator 200 MHz, timebase accuracy 0.25 ppm
Cable BNC (m)(m) 48-inch
Adapter Type N (m) to BNC (f)

Set up the equipment

Turn on the equipment required and the logic analyzer. Let them warm up for 30
1 1
minutes if you have not already done so.
Set the signal generator to 181.81818 MHz (5.5 ns period) and approximately 600 mV
2 2
rms.
3–86
Recommended
Model/Part
HP 8656B Opt. 001
HP 10503A
HP 1250-0780