Headers - Supermicro SuperStorage SSG-6029P-E1CR24H User Manual

SuperStorage SSG-6029P-E1CR24H/L User's Manual
VGA Port
The onboard VGA port is located next to IPMI LAN port on the I/O back panel. Use this
connection for VGA display.
Serial Port
There is one COM port (COM1) on the I/O back panel. The COM port provides serial
communication support.

4.3 Headers

Onboard Fan Header
Five 4-pin fan headers (FAN1~5) are located on the motherboard to provide CPU/system
cooling. These fan headers support both 3-pin fans and 4-pin fans; however, onboard fan
speed control is available only when all 4-pin fans are used in the motherboard. Fan speed
control is supported by a thermal management setting in the BMC (Baseboard Management
Controller). See the table below for pin definitions.
NVMe Connectors
Use the NVMe connectors (P1_NVMe0/P1_NVMe1/P1_NVMe2/P1_NVMe3) to attach high-
speed PCI-E storage devices (supported by CPU1).
I-SATA 3.0 and S-SATA 3.0 Ports
The X11DSC+ has eight I-SATA 3.0 ports (I-SATA0-3, I-SATA4-7) and six S-SATA ports
(S-SATA0-3, S-SATA4, S-SATA5) on the motherboard. The I-SATA ports are supported by
the Intel PCH C621 chipset, and the S-SATA ports are supported by Intel SCU. S-SATA4/S-
SATA5 can be used with Supermicro SuperDOMs which are yellow SATA DOM connectors
with power pins built in, and do not require external power cables.
Fan Header
Pin Definitions
Pin# Definition
1 Ground (Black)
2 +12V (Red)
3 Tachometer
4 PWM Control
SATA 3.0 Port
Pin Definitions
Pin# Signal
1 Ground
2 SATA_TXP
3 SATA_TXN
4 Ground
5 SATA_RXN
6 SATA_RXP
7 Ground
66