Supermicro SuperStorage SSG-6029P-E1CR24H User Manual page 75

Watch Dog
JWD1 controls the Watch Dog function. Watch Dog is a monitor that can reboot the system
when a software application hangs. Jumping pins 1-2 will cause Watch Dog to reset the system
if an application hangs. Jumping pins 2-3 will generate a non-maskable interrupt signal for the
application that hangs. Watch Dog must also be enabled in BIOS. The default setting is Reset.
Note: When Watch Dog is enabled, the user needs to write their own application software
to disable it.
Manufacturing Mode Select
Close JPME2 to bypass SPI flash security and force the system to use the Manufacturing
Mode, which will allow you to flash the system firmware from a host server to modify system
settings. See the table below for jumper settings.
I2C Bus for VRM
Jumpers JVRM_SEL1 allows the BMC or the PCH to access CPU and memory VRM
controllers. See the table below for jumper settings.
Watch Dog
Jumper Settings
Jumper Setting Definition
Pins 1-2 Reset
Pins 2-3 NMI
Open Disabled
Manufacturing Mode Select
Jumper Settings
Jumper Setting Definition
Pins 1-2 Normal (Default)
Pins 2-3 Manufacturing Mode
VRM
Jumper Settings
Jumper Setting Definition
Pins 1-2 BMC (Normal)
Pins 2-3 PCH
75
Chapter 4: Motherboard Connections