Supermicro SuperStorage SSG-6029P-E1CR24H User Manual page 109

Network Stack Configuration

Network Stack
Select Enabled to enable UEFI (Unified Extensible Firmware Interface) for network stack
support. The options are Disabled and Enabled.
*If the item above "Network Stack" is set to Enabled, the following items will be
displayed:
Ipv4 PXE Support
Select Enabled to enable Ipv4 PXE boot support. The options are Disabled and Enabled.
Ipv4 HTTP Support
Select Enabled to enable Ipv4 HTTP boot support. The options are Disabled and Enabled.
Ipv6 PXE Support
Select Enabled to enable Ipv6 PXE boot support. The options are Disabled and Enabled.
Ipv6 HTTP Support
Select Enabled to enable Ipv6 HTTP boot support. The options are Disabled and Enabled.
PXE boot wait time
Use this option to specify the wait time to press the ESC key to abort the PXE boot. Press
"+" or "-" on your keyboard to change the value. The default setting is 0.
Media detect count
Use this option to specify the number of times media will be checked. Press "+" or "-" on
your keyboard to change the value. The default setting is 1.
Super IO Configuration
Super IO Configuration
The following Super IO information will be displayed:
•
Super IO Chip AST2500
Serial Port 1 Configuration
Serial Port 1 Configuration
This submenu allows the user the configure settings of Serial Port 1.
Serial Port 1
Select Enabled to enable the selected onboard serial port. The options are Disabled and
Enabled.
109
Chapter 6: UEFI BIOS