Supermicro SuperStorage SSG-6029P-E1CR24H User Manual page 107

SATA Port 0~ Port 3
This item displays the information detected on the installed SATA drive on the particular SATA
port.
•
Model number of drive and capacity
•
Software Preserve Support
Hot Plug (SATA Port 0~ Port 3)
Select Enabled to enable a SATA port specified by the user. The options are Disable and
Enable.
Spin Up Device (SATA Port 0~ Port 3)
On an edge detect from 0 to 1, set this item to allow the PCH to initialize the device. The
options are Disable and Enable.
SATA Device Type (SATA Port 0~ Port 3)
Use this item to specify if the SATA port specified by the user should be connected to a Solid
State drive or a Hard Disk Drive. The options are Hard Disk Drive and Solid State Drive.
PCIe/PCI/PnP Configuration
The following information will be displayed:
•
PCI Bus Driver Version
PCI Devices Common Settings:
Above 4G Decoding (Available if the system supports 64-bit PCI decoding)
Select Enabled to decode a PCI device that supports 64-bit in the space above 4G Address.
The options are Disabled and Enabled.
SR-IOV Support
Use this feature to enable or disable Single Root IO Virtualization support. The options are
Disabled and Enabled.
MMIO High Base
Use this item to select the base memory size according to memory-address mapping for the
IO hub. The base memory size must be between 4032G to 4078G. The options are 56T,
40T, 24T, 16T, 4T, and 1T.
MMIO High Granularity Size
Use this item to select the high memory size according to memory-address mapping for the
IO hub. The options are 1G, 4G, 16G, 64G, 256G, and 1024G.
107
Chapter 6: UEFI BIOS