Supermicro SuperStorage SSG-6029P-E1CR24H User Manual page 69

4-pin BMC External I2C Header
A System Management Bus header for IPMI 2.0 is located at JIPMB1. Connect the appropriate
cable here to use the IPMB I2C connection on your system. Refer to the table below for pin
definitions.
NVMe SMBus Headers
NVMe SMBus (I2C) headers (JNVI2C1/2), used for PCI-E SMBus clock and data connections,
provide hot-plug support via a dedicated SMBus interface. This feature is only available for a
Supermicro complete system with an SMCI-proprietary NVMe add-on card and cable installed.
See the table below for pin definitions.
SMB (I2C) for LCD Connector
The connector used for System Management Bus (I2C) for LCD devices is located at JI2C_
FP1. Connect a cable here to provide health monitoring and management for LCD devices.
SMB (I2C) for SAS3 Backplanes Connectors
JI2C_EXP1/2 connectors are used for System Management Bus (I2C) for the devices installed
on the SAS3 backplanes. Connect appropriate cables to these connectors for SAS3 health
monitoring and system management.
Disk-On-Module Power Connector
The Disk-On-Module (DOM) power connectors at JSD1 and JSD2 provide 5V power to a
solid-state DOM storage devices connected to one of the SATA ports. See the table below
for pin definitions.
Chapter 4: Motherboard Connections
External I2C Header
Pin Definitions
Pin# Definition
1 Data
2 Ground
3 Clock
4 No Connection
NVMe SMBus Header
Pin Definitions
Pin# Definition
1 Data
2 Ground
3 Clock
4 VCCIO
DOM Power
Pin Definitions
Pin# Definition
1 5V
2 Ground
3 Ground
69