Supermicro SuperStorage SSG-6029P-E1CR24H User Manual page 68

SuperStorage SSG-6029P-E1CR24H/L User's Manual
SGPIO Header
The I-SGPIO1 (Serial General Purpose Input/Output) header is used to communicate with
the enclosure management chip on the backplane.
Standby Power
The Standby Power header is located at JSTBY1 on the motherboard. You must have a card
with a Standby Power connector and a cable to use this feature. Refer to the table below
for pin definitions.
Power SMBus (I2C) Header
The Power System Management Bus (I2C) header at JPI2C1 monitors the power supply input/
output voltages, fans, temperatures, and status. Refer to the table below for pin definitions.
Chassis Intrusion
A Chassis Intrusion header is located at JL1 on the motherboard. Attach the appropriate cable
from the chassis to inform you of a chassis intrusion when the chassis is opened. Refer to
the table below for pin definitions.
SGPIO Header
Pin Definitions
Pin# Definition Pin# Definition
1 NC 2 NC
3 Ground 4 DATA Out
5 Load 6 Ground
7 Clock 8 NC
NC = No Connection
Standby Power
Pin Definitions
Pin# Definition
1 +5V Standby
2 Ground
3 No Connection
Power SMBus Header
Pin Definitions
Pin# Definition
1 Clock
2 Data
3 PMBUS_Alert
4 Ground
5 +3.3V
Chassis Intrusion
Pin Definitions
Pin# Definition
1 Intrusion Input
2 Ground
68