Using Combo Autotest - JDS Uniphase Wavetek DSAM Series Quick Start Manual

Chapter 2 DSAM Meter Operation
Using AutoTests Mode
Using Combo
Autotest
42
Figure 29 AutoTests Menu
You are ready to perform tests in AutoTest mode only
when:
– The meter is receiving power
– The RF cable is connected to the meter (on the back
panel)
– Your DSAM meter has been configured to conduct
AutoTest measurements (see
on page 23)
To access the Combo Autotest mode, use the arrow keys
to highlight the Combo Test option on the AutoTests mode
menu (Figure 29), and press Enter. The first Combo Test
screen you see will look similar to
DSAM Product Family Quick-Start Guide Rev. 001
"Configuring the Meter"
Figure 30 on page 43.