JDS Uniphase Wavetek DSAM Series Quick Start Manual page 31

DSAM Product Family Quick-Start Guide Rev. 001
12 Volt
DC Port
Figure 3 DSAM Battery
The green "OK" LED illuminates to indicate that the battery
is completely charged.
The red "CHARGE" LED illuminates to indicate the
present charge condition. Under normal charging condi-
tions, this LED should remain on constantly. A flashing
LED is indicative of a fault condition. To interpret the
"CHARGE" LED indications, review
Table 6 Charge LED indications
LED color
Red Steady
(CHARGE)
Flashing
Green (OK) Steady
For information about the charger module's specifications,
see Table 9 on page
Chapter 2 DSAM Meter Operation
Battery and charge
State
condition
Charging
Charge fault check:
– Temp too high/low or,
– DC too high/low or,
– Internal fault
Charge Complete
64.
Powering the Meter
Charge
Indicator
LEDS
Table 6.
15