Install The Coffee Module; Install The Milk Module - Nespresso Momento 120 Service Manual

4.3.4 Install the Milk Module

1. Open the water tank door and insert the milk module into the related slot of the
main housing and place it on the guide rails at the bottom.
2. Carefully slide the milk module into the main housing until it stops.
3. Fasten the Tri-Wing screw at the bottom of the milk module.
4. Open the milk module door.
5. Remove the screw cover and fasten the Tri-Wing screw on the top part of the milk
module.
6. Put the screw cover back and close both doors.
Perform an insulation resistance test to finish the modules installation.
→ p. 207
Milk foam quality must be checked and adjusted after every installation
→ p. 28
Version 1.4 EN
Installation > Assembling Coffee and Milk Module
Momento 120 Service Manual
Risk of damage!
ensure that the
milk module was
standing upright for
at least 24 h before
switching on the
machine after the
module installation, to
avoid damage to the
fridge compressor.
Fig. 18
Fig. 19
25