Initial Boot And Settings; Modem Connectivity Check; Dwc Set Up (If Installed); Set Agent Code - Nespresso Momento 120 Service Manual

According to the
time zone defined,
set the volume in L
(litres) or gal (gallons).
this step is
mandatory to
allow the correct
transmission of
telemetry data!
26
Installation > Initial Boot and Settings

4.4 Initial Boot and Settings

4.4.1 Modem Connectivity Check

The connectivity information is only displayed on the MMI during machine
boot-up.
network quality
IMEI=357042068074468
ICCID=8934075200002786745
APN=nespresso.movistar.es
Network=3G
AWS=ssl://a1o7bsccv23bd5.iot.eu-west-1.amazonaws.com:8883
Minimum Requirement
Network
Network quality
Not meeting this requirements, the telemetry might still work but remote firmware
update will not.
The installation of an external antenna can help finding better coverage as you can
place it away from electromagnetic noise or a bit closer to the signal source.
Recommended start position is on machine right panel as close as possible to the
upper right corner.
Reboot the machine to check the signal quality again after every time you moved the
antenna.

4.4.2 DWC Set Up (if installed)

The external filter capacity has to be set when activating the DWC function:
would you like to activate
the direct water
connection feature?

4.4.3 Set Agent Code

The Agent code setting is not part of the setup wizard and must be done manually
after assembling and installing the modules → p. 39.
Momento 120 Service Manual
3G
Minimum of 2 dots
yes
enter the external filter
capacity
no
X X X L
Version 1.4 EN