Replace Pressure Sensor - Nespresso Momento 120 Service Manual

Removing FEP
tubes: → p. 142
164
Repair > Milk Module Repairs (Plastic Component Support)

11.13.3 Replace Pressure Sensor

2
1
This component and connected pipes are under pressure (→ p. 15),
follow the instructions on page 140 in advance!
Prerequisites
• Hydraulic unit and PCB assembly are detached → p. 160.
Procedure
1. Remove the FEP tube (A) from the pressure sensor (1).
2. Cut the cable tie (2) and unplug the connector of the pressure sensor (1).
3. Slide the pressure sensor (1) out of the holding plate (3).
Assembly tip
• Don't forget to fix the pressure sensor's connector with a cable tie.
Momento 120 Service Manual
3
A
Fig. 133
Version 1.4 EN