Table of Contents
Advertisement
SuperStorageSystem SSG-6048R-E1CR45H/L User's Manual
6-5
Installing the HDD Support Partitions
Figure 6-7. Installing the Hard Drive Support Partitions
Prior to installing top-loading 3.5" hard drives into the SC946LTS chassis, it is
necessary to install the two hard drive support partitions included with the system.
Installing the HDD Support Partitions
1. Power down the system and disconnect the AC power cords from the rear of
the power supplies. Open the chassis cover as described in Section 6-3.
2. Place the HDD support partitions into the storage chassis as illustrated above.
3. Flex the partition bar slightly while simultaneously holding open the latches at
each end of the partition.
4. Slide the partitions onto the dividers and release the latches to clip the parti-
tion to the divider
5. Secure the dividers to the storage chassis using five screws.
6. Close the storage chassis cover, reconnect the power cords to the rear of the
power supplies and power up the system.
6-6
Advertisement
Table of Contents
