Installing Nvme Drive Carriers Into The Nvme Drive Cage - Supermicro SuperStorageSystem 6048R-E1CR45H User Manual

Installing NVMe Drive Carriers into the NVMe Drive Cage

NVMe drives are hot-swappable and once the NVMe drive cage has been installed
as described in the beginning of this section, the NVMe drives can be added to or
removed from the NVMe cage without powering down the system.
Installing NVMe Drives and Carriers into the Storage Chassis
1. Grasp the drive carrier handle.
2. Push the hard drive carrier into the hard drive bay until it clicks into the
locked position.
Removing NVMe Drives and Carriers from the NVMe Drive Cage
1. Push the release button on the drive carrier. This will extend the drive carrier
handle.
2. Grasp the drive carrier handle and pull the carrier up and out of the NVMe
cage.
Warning: Enterprise level hard disk drives are recommended for use in Supermicro
storage chassis and servers. For information on recommended HDDs, visit the
Supermicro website at www.supermicro.com.
Figure 6-15. Logical Numbering of Hard Drive Layout
Chapter 6: Advanced Chassis Setup
Drive #s 0-5 (left to right)
Drive #s 45-59 (left to right)
Drive #s 30-44 (left to right)
Drive #s 15-29 (left to right)
Drive #s 0-14 (left to right)
6-13