Table of Contents
Advertisement
Steps to be performed when operating the machine (sewing and
equipping)
Steps to be performed for service, maintenance, and installation
Steps to be performed via the software control panel
The individual steps are numbered:
First step
1.
Second step
2.
The steps must always be followed in the specified order.
...
Lists are marked by bullet points.
•
Result of performing an operation
Change to the machine or on the display/control panel.
Important
Special attention must be paid to this point when performing a step.
Information
Additional information, e.g. on alternative operating options.
Order
Specifies the work to be performed before or after a setting.
References
Reference to another section in these instructions.
Important warnings for the user of the machine are specifically marked.
Safety
Since safety is of particular importance, hazard symbols, levels of danger and
their signal words are described separately in the chapter Safety ( p. 7).
If no other clear location information is used in a figure, indications of right
Location
information
or left are always from the user's point of view.
4
Operating Instructions 745-35-10 B/745-35-10 F - 00.0 - 04/2017
About these instructions
Advertisement
Table of Contents
