Table of Contents
Advertisement
Operation
Checking the cutting pattern
Fig. 27: Checking the cutting pattern
• Straight pocket corners: the right and the left corner knife cuts are
• Slanted pocket corners: the left corner knife cut is offset by +/- 13 mm
4.16 Setting the reference position
The reference position is necessary in order to obtain a defined initial
position.
To set the reference position:
1. Switch on the machine.
The control is initialized.
2. Press the left pedal back.
The reference run starts.
4.17 Performing a quick stop
To perform a quick stop:
1. Press the pedal back.
The current step of the positioning sequence or the sewing cycle is
2. Press the pedal back again.
The transport carriage moves out of the loading area.
Operating Instructions 745-35-10 B/745-35-10 F - 00.0 - 04/2017
parallel to one another
relative to the right corner knife cut
The control checks whether the transport carriage is at its rear end
position. Otherwise, the display shows the message
Info 9000
The transport carriage moves to its rear end position.
The display switches to the main screen.
stopped immediately.
The display shows the message Error 9601
.
.
37
Advertisement
Table of Contents
