DURKOPP ADLER 745-35-10 B Operating Instructions Manual page 53

Operation
The total length L of a piping incision always amounts to approx. 45-50 mm
(dependent on the sewing material) and cannot be altered. The programma-
ble value S indicates the length of the cut within the pocket length T.
The value S has been preset to 15 mm With this setting, the piping strip is
incised 30 mm from the seam.
To shift the cut, set value S as follows:
Operating the piping incision device
The piping incision device is activated at the OP7000 control panel
( p. 140).
Fig. 44: Operating the piping incision device
(1) - lateral stop
(2) - Stops
Positioning a double pipe
To position a double pipe:
1. Position the piping strip at the front or rear stop (2).
2. Position the piping strip at the lateral stop (1).
3. Start sewing.
Positioning a single pipe
To position a single pipe:
1. Position the piping strip at the front or rear stop (2).
2. Position the piping strip at the center stop (3).
3. Start sewing.
Operating Instructions 745-35-10 B/745-35-10 F - 00.0 - 04/2017
• To shift the cut to the middle of the pocket: Increase value S
• To shift the cut outward: Decrease value S
① ② ③
(3) - Center stop
51