Table of Contents
Advertisement
SVS-200
Programming Menu Entry
1. To enter the programming modes from the main menu, press ENTER when the desired
programming mode is SELECTED.
2. You will be prompted enter the access code. Contact your Authorized PosiCharge™ dealer
for the code, or call customer service at
3. Once the access code has been accepted the screen will change and hold for five (5) seconds
to indicate you have entered programming mode.
4. If programming mode is entered while the charger is charging, the user will be prompted to
Cancel (Default) terminating the charge or to OK the programming mode. Use the UP and
DOWN arrow keys to toggle between OK and Cancel, and press ENTER to choose the
desired option or CLEAR to Cancel. If a vehicle is not connected, this step will be skipped.
5. After authorization, the selected programming mode is now active.
5.10
Charger Configuration
The charger stores configuration information for several parameters. Each of these, except
Charge Algorithms, may be edited by the user from the charger configuration menu (see
). These data are stored in the charger and are preserved even if power is removed from the
11
charger.
1. Clear Backup Memory Data allows the user to clear the memory in the charger, which
contains charge events, fault events, and charger configuration parameters.
2. External Light Configuration allows the user to set two modes of operation: Selector Mode and
3 external lights can be configured to monitor any of the 5 following states of Charger
operation: Connected and Stop Charging, Connected and Charging, Connected and
Equalizing, Port available and Fault or Warning. This feature is only applicable in systems
where external lights have been installed and connected to the charger.
20153-W-03-01
IMPORTANT INFORMATION – SAVE THESE INSTRUCTIONS
Figure 5- 10 Programming Menu Entry
Installation, Operation and Maintenance
866-POSICHARGE (866-767-4242).
24
Webasto Charging Systems, Inc.
Figure 5-
Advertisement
Table of Contents
