Barco R9002328 Owner's Manual page 37

A new battery (not yet installed to save the battery life
time) is delivered inside the plastic bag with the power
cord. Before using the RCU, start first the battery
installation procedure.
Remove the battery cover on the backside of the
remote control by pushing the indicated handle a little
to the bottom of the RCU. Lift up the top side of the cover
at the same time (fig. 1).
Insert the new 9 V battery (E-block type, e.g. 6F22S
or equivalent) in the lower compartment and connect
the battery to the contact plate.
Insert the battery into the lower compartment and put
the cover back.
5-2
All manuals and user guides at all-guides.com
Contact
plate
Battery
fig.1
Insert here,
behind the
plastic cover,
the 'Insert card
for RCU'. You
can cut out the
correct insert
card on one of
the last pages of
this manual.
fig.2
310a.DRW
R5975059A BARCOVISION 708 200498