Barco R9002328 Owner's Manual page 153

Follow the steps below to create a second adjustment block for a source between
0 and 9.
1. Select the source between 0 and 9 that the second adjustment block is to be
created for.
2. Select the corresponding source number between 90 and 99. The adjustment
block for the source number between 0 and 9 is copied to the corresponding
source number between 90 and 99.
3. Enter the adjust mode and make any desired changes (geometry, convergence,
sync fast/slow, enhanced blue on/off) to the second adjustment block.
4. Exit the adjust mode.
Note : the above also applies to source number 1 - 5 and 91 - 95 of a stand alone
projector (no RCVDS).
E-2
All manuals and user guides at all-guides.com
R5975059A BARCOVISION 708 200498