Barco R9002328 Owner's Manual page 152

All manuals and user guides at all-guides.com
Source numbers 90 - 99 do not correspond to physical inputs to the projector or
RCVDS05. They are used to assign an additional adjustment block to a source. This
additional adjustment block may contain different geometry and convergence
settings, sync fast/slow positions and enhanced blue on/off settings.
relationship between source numbers 0 - 9 and 90 - 99 (projector with RCVDS)
or 1 - 5 and 91 - 95 (stand-alone projector) is shown in the diagram below.
source input 0
source input 1
source input 2
source input 9
The alternate adjustment block for sources 0 - 9 (projector with RCVDS) or 1 - 5
(stand-alone projector) is activated by selecting
number 0 - 9 (projector with RCVDS) or 1 - 5 (stand-alone projector). Once this
source number is selected, the alternate block of adjustment data is in use and may
be modified via the adjust mode of the projector. The alternate adjustment block
is automatically stored.
R5975059A BARCOVISION 708 200498
source number 0 Block header A
source number 90 Block header A, different
analog settings
source number 1 Block header B
source number 91 Block header B, different
analog settings
Block header C
source number 2
Block header C, different
source number 92
analog settings
source number 9 Block header J
source number 99 Block header J, different
analog settings
the corresponding source
The
E-1