Barco R9002328 Owner's Manual page 23

Use the supplied power cord to connect your projector to the wall outlet. Plug
the female power connector into the male connector at the front of the projector.
The projector is switched ON and OFF using the power (mains) switch ON/OFF.
Pressed : ON
Not pressed : OFF
The projector can start now in the 'operational mode' (image displayed) or in the
'stand by mode', depending on the position of the 'power up' dip switch on the
controller unit. This DIP switch is set during installation by a qualified technician.
If you want to change this start up mode, call a qualified technician.
Stand by indication lamp :
no light up : projector in operational mode
red : projector is in stand by.
LEDs on the front plate of the projector
3-2
All manuals and user guides at all-guides.com
See installation instructions before
connecting to the supply
OFF ON
See installation instructions before
V NOM 120/230 Volt
connecting to the supply
I MAX 5/2.5 AMP
OFF ON
FREQ 60/50 Hz
V NOM 120/230 Volt
I MAX 5/2.5 AMP
FREQ 60/50 Hz
R5975059A BARCOVISION 708 200498