Section 8: Changing Of Front And Rear Cover Lenses; Section 9: Prolite Auto-Darkening Filter Lens Controls - ESAB CIGWELD 454342 Operating Manual

ProLite Welding Helmet

SECTION 8: Changing of Front and Rear Cover Lenses

If any of the Cover Lenses is broken, plainly worn, distorted or contaminated it should be replaced immediately with a genuine Cigweld
replacement part.
REPLACING FRONT COVER LENS
1. To replace the front cover lens unclip the filter lens from the top and bottom mounting bracket. Remove the existing front cover
lens and replace with new one. Ensure that when installing the filter lens is fastened securely to prevent any fumes passing
through.
REPLACING REAR COVER LENS
2. Remove the rear cover lens by pulling up the recessed centre edge of the lens and the rear covers will pop out of its tabs.
Replace the existing rear cover lens by sliding the lens under the tabs on one side first and then massage the other side so that
it slide under the tabs and sits securely.
Ensure both cover lenses are securely in place before use.

SECTION 9: ProLite Auto-Darkening Filter Lens Controls

For your protection and maximum efficiency of your product, please study this information carefully before use.
Welding/Grinding Mode
1. The Welding/Grinding mode switch is used to change the Filter Lens between Welding and Grinding modes. Note that additional
eye and face protection is recommended when Grinding.
Sensitivity Control
2. The Sensitivity Control is used to make the Filter Lens more or less responsive to different light levels. Manually adjust the
sensitivity as required for the application.
Variable Shade Control
3. The Variable Shade Control is used to adjust the shade level between 9-13. Manually adjust shade to desired level as required
for the application.
Delay Switch
4. The Delay Switch is used to adjust the hold time of the Filter Lens after welding is completed. Manually adjust delay time to
desired level as require for application.
Battery Test Button
1. The battery life can be tested by pressing on the test button. When depressed the filter lens will change to a darkened state and
led indication will light. If the led indication fails to light or is quite dim, please replace the lithium batteries. Refer to point 2 for
battery replacement details.
16
2
1
3
Figure 9-1
Art # A-12257
4
0-5296