JUKI AMS-220EN / IP-420 Instruction Manual page 40

Button and display
G
SEWING SHAPE NO. display
H
SEWING SHAPE SELECTION
button
I
NEEDLE THREAD TENSION
SETTING button
J
X ACTUAL SIZE VALUE display
K
X SCALE RATE SETTING
button
L
Y ACTUAL SIZE VALUE display
M
Y SCALE RATE SETTING
button
N MAX. SPEED LIMITATION
O
FOLDER NO. display
P
FOLDER SELECTION button
Q
PATTERN REGISTER button
Kind and No. of the sewing shape being selected at present is displayed.
There are 4 kinds below of the kinds of sewing shape.
: Users' pattern
: Vector format data
: M3 data
: Sewing standard format
* Be sure to use the media that has been formatted with IP-420.
For the formatting procedure of the media, refer to
"II-2-28. Performing formatting of the media" p.90 .
Sewing shape being selected at present is displayed on this button and
when the button is pressed, the sewing shape selection screen is
displayed.
→ Refer to "II-2-5. Performing sewing shape selection" p.39 .
Needle thread tension value which is set to the pattern data being selected
at present is displayed on this button and when the button is pressed, the
item data change screen is displayed.
to"II-2-6. Changing item data" p.41
→ Refer
Actual size value in X direction of sewing shape being selected at present
is displayed.
When the actual size value input is selected by setting memory switch
, X actual size value setting button is displayed.
→ Refer to "II-2-6. Changing item data" p.41
Scale rate in X direction of sewing shape being selected at present is
displayed on this button.
When the scale input is set to non-selection by setting memory switch
, the button goes out and the X scale is displayed.
→ Refer to "II-2-6. Changing item data" p.41
Actual size value in Y direction of sewing shape being selected at present
is displayed.
When the actual size value input is selected by setting memory switch
, Y actual size value setting button is displayed.
→ Refer to "II-2-6. Changing item data" p.41
Scale rate in Y direction of sewing shape being selected at present is
displayed on this button. When the scale input is set to non-selection by
setting memory switch
displayed. → Refer to "II-2-6. Changing item data" p.41
Maximum speed limitation which is set at present is displayed on this button
and when the button is pressed, the item data change screen is displayed.
(However, maximum speed limitation which is displayed is different from
the maximum number of revolutions in the pattern.)
"II-2-6. Changing item data" p.41
→ Refer to
Pattern register button which is displayed indicates the folder No. which has
been stored.
Folders to display the patterns are displayed in order.
PATTERN REGISTER buttons stored in O FOLDER NO display are displayed.
→ Refer to "II-2-15. Performing new register of pattern button" p.55 .
* This button is not displayed unless the new register to the pattern button
is performed.
– 36 –
Description
.
.
.
.
, the button goes out and the Y scale is
.
.