3-14. Connecting the pneumatic components (Pneumatic type only)
[Connection common to all areas]
When using the air-driven type model, connect the pneumatic components as described below.
❶
❼
❽
❼
1) Install regulator ❶ to installing plate ❷ , and
❸
❷
2) Connect the cord coming from the regulator
❹
❺
3) Install solenoid valve asm. ❽ on solenoid
❻
❾
4) Fix the air tube using cable clip supplied with
– 14 –
install it to the stand with screw ❸ , washer ❹
and nut ❺ .
with CN78 (air relay cable).
(Refer
to"I-3-11. Connecting the cord [Wiring
diagram of circuit board]"
valve installing plate ❻ in the direction as
shown in the figure, using screw ❼ supplied as
accessories.
In addition, fix one side of accessory ground
code (length: 20 cm) ❾ with setscrew ❼
together with solenoid valve mounting plate ❻ .
the machine as accessories. (For the setscrew,
use setscrew fixing the motor cover.)
p.11.)