Installing The Electrical Box; Connecting The Power Switch Cord (Japan And General Export Area); Installing The Operation Panel (It-100D) - JUKI IT-100D Instruction Manual

4-5. Installing the electrical box

5
6
7

4-6. Connecting the power switch cord (Japan and general export area)

2
A
5
4

4-7. Installing the operation panel (IT-100D)

2
3
1
2
3
4
1
6
9
B
7
8
3
1
3
3
Install the electrcal box on the under sde of the
table usng round-head bolts 1 , plan washers 2 ,
sprng washers 3 and nuts 4 suppled wth the ma-
chne at the locaton llustrated, and usng bolt havng
hexagonal ndentaton on the head 5 , sprng washer
6 and plan washer 7 suppled wth the machne at
the locaton llustrated.
1) Loosen screw 1 located on the sde of the power
swtch suppled as accessores and remove the
power swtch cover.
2) Connectng the nput power cord of electrcal box
¡When the input power cord of electrical box is 4P
Put 4P cord from hole A of the power swtch and
securely fix green/yellow cord to 5 , whte cord to 2 ,
black cord to 3 and red cord to 4 wth screws.
¡When the input power cord of electrical box is 3P
Put 3P cord from hole A of the power swtch and
securely fix green/yellow cord to 5 , brown cord to
2 and sky blue cord to 3 wth screws.
3) Connectng the power cable suppled as accessores
¡In case of 3-phase power cable
Put power cable from hole B of the power swtch, and
securely fix green/yellow cord to 9 , whte cord to 6 ,
black cord to 7 and red cord to 8 wth screws.
¡In case of single phase power cable
Put power cable from hole B of the power swtch,
and securely fix green/yellow cord to 9 and other
cords to 6 and 7 wth screws. 8 s not used.
4) Installng the power swtch cover
Securely tghten screw 1 located on the sde of
the power swtch.
1) Install operaton panel 1 on the machne head
usng screws 3 whch have been assembled to
panel nstallng bracket 2 .
Do not disassemble the operation
panel to prevent it from breakage.
– 6 –