Installing The Control Panel - JUKI CP-170 Instruction Manual

WARNING :
This Instruction Manual is for the control panel, CP-170.
Read "Safety Instructions" of the Instruction Manual for the control box carefully beforehand and
understand them before using CP-170.
In addition, be careful not to splash water or oil on it, or shock such as dropping and the like since
this product is a precision instrument.

1. INSTALLING THE CONTROL PANEL

WARNING :
To prevent personal injury caused by abrupt start of the sewing machine, carry out the work after
turning OFF the power switch and ascertaining that the motor has completely stopped.
1
) Remove side plate setscrews 1 from the side plate.
2) Install control panel 2 on the machine head using screw 1 , flat washer 3 and rubber seat 4 supplied
as accessories.
< The relation between the respective machine heads and the positions of installing hole of the
bracket are as described in the table. >
1 2
3
The screws supplied with the machine as the accessories are for LH-3100. When they are used for
other machine heads, there is a possibility that the screw hole is crushed.
Do not use the screws supplied with the machine as the accessories with the machines other than
LH-3100.
When installing the control panel on DDL-8700, the machine with AK device is different from that
without the device in installing procedure.
With AK device : Install the control panel on the machine head bracket supplied with the AK device.
Without AK device : Remove the side plate setscrews and install on the side plate.
4 5
6
2
4
DDL-9000A
DLN-900
LH-300
LZ-2280
LH-400
LH-3500
DDL-8700 Series
-  -
3
1
Installing hole Screw
1 - 5 M5
2 - 5 3/6-28
3 - 5 /64-40
3 - 5 3/6-28
2 - 5 M5
2 - 5 M5
3 - 6 3/6-28