Table of Contents
Advertisement
3-3. Installation of the sewing machine head
WARNING :
To prevent possible accidents caused by the full of the sewing machine, perform the work by two
persons or more when the machine is moved.
A
3-4. Installing the drain receiver and the head support rubber
❼
❻
❻
❻
❶
❹
❶
❸
❻
❷
❻
❽
❺
1) Fit the holes of hinges A to the holes of table
and fix as shown in the figure.
In case of the pneumatic type, fix sole-
noid valve installing plate ❶ as well.
1) Fix drain receiver ❷ in the installing hole of
table ❶ with two setscrews ❸ .
2) Screw in drain bin ❹ to drain receiver ❷ .
3) Insert sewing machine drain pipe ❺ into drain
bin ❹ .
4) Insert head support rubbers ❻ to machine bed ❼ .
5) Bundle the cables with clip bands ❽ as shown
in the figure. (Excluding air tube)
1. Insert drain pipe ❺ until it will go
no further so that it does not come
off drain bin ❹ when tilting the ma-
chine head.
2. Remove the tape fixing drain pipe
❺ .
❻
– 5 –
Advertisement
Table of Contents
