Table of Contents
Advertisement
RH850/U2A 292pin
Note
Please keep the Y-RH850-U2A-292PIN-PB-T1-V1 packing box at hand for later reuse in sending the
product for repairs or for other purposes. Always use the original packing box when transporting the Y-
RH850-U2A-292PIN-PB-T1-V1. If packing of your product is not complete, it may be damaged during
transportation.
1.2
Supported Main Boards
This piggyback board can be used as a standalone board, or it can be mated with a main board. The following main
boards are supported:
•
Y-RH850-X1X-MB-T1-V1
•
Y-RH850-X1X-MB-T2-Vx
•
Y-RH850-X2X-MB-T1-V1
1.3
Main Features
•
Burn-in socket for mounting of the device
•
Several power set-up options
−
Combined operation with powering from main board
−
Stand-alone operation with single power supply (e.g. 3.3 V or 5.0 V only)
−
Stand-alone operation with flexible, individual power supply (typ. 1.12 V, 3.3 V, 5.0 V)
Refer to 3.3 Device Core Voltage (VDD) Selection for further details about VDD voltage.
•
Debugging and programming interface:
−
14-pin LPD/JTAG Debug Connector (e.g. for using E2 OCD Emulator or PG-FP6 Flash Programmer)
•
Pin headers for direct access to each device pin
•
Reset switch
•
External clock circuit with an exchangeable 16/20/24/40 MHz Crystal Resonator
•
General purpose signaling LEDs
•
Jumpers for device mode selection and other configuration options
•
Automotive Ethernet Port 100/1000BASE-T1
•
On-board interface connector for
−
Renesas High-Speed Serial I/F (RHSIF)
or
−
Multichannel Serial Peripheral Interface (MSPI)
•
Operating temperature from 0 °C to +40 °C
R20UT4545ED0102 Rev.1.02
May 27, 2021
1. Overview
Page 7 of 58
Advertisement
Table of Contents
