Users Guide - Dantherm Silencio 600 Service Manual

Overview
This section only describes how to activate/use the different functions.
Introduction
Under each of the functions below, you will find relevant references if further
information is needed.
You can test all functions in the Silencio by pushing a sharp object against the test
Test
button. The unit will then perform a self-test for about 5½ minutes.
See more about the different test points in section "Description of the control board",
page 14.
See more about the test mode in section "Functional description", page 17.
For fault finding please see section "Fault finding guide", page 71.
Occupied function You can force the Silencio in service mode by pushing a sharp object against the
occupied button on the control board.
For further description on this mode, please see section "Functional description",
page 17.
You can with a screwdriver adjust the cooling and heating set points on the dials on the
Set points
controller.
Limitations in set points: Please notice that the minimum difference between cooling
For further information about the set points, please see section "Set points", page 20.

Users guide

and heating set point must be 10 degrees or more to avoid
fighting between active cooling and heating.
31