Unwrapping - Dantherm Silencio 600 Service Manual

Unwrapping

Introduction
Important!
Procedure
Check content
24
This section will guide you through the unwrapping of the Silencio unit.
Do not remove the male SUB-D plug on the front of the unit!
Follow these steps to unwrap the unit:
Step
1 Remove all the cardboard and the plastic bag from the unit and throw it
away
Please check the content when having received and unwrapped the Silencio unit.
The following should be included in a plastic bag on top of the unit under the roof:
2 × Wall bracket
1 × Support bracket, left
1 × Support bracket, right
2 × Hex head bolt M8 x 70 mm incl. 4 × Washer M8
For mounting the support brackets on the wall brackets
2 × Hex head bolt M8 x 40 mm incl. 2 × Nut M8
For the fine adjustment on the support brackets
7 × Hex head bolt M8 x 130 mm incl. 7 Washer M8 and 7 × nut M8
For mounting of the 2 wall brackets and top mounting
Note: The bolts are suitable for wall thicknesses up to 100 mm.
Please find suitable bolts if wall thickness is more than 100 mm
6 m Sealing, 10 × 30 mm Norton
Action
•
•
•