Mounting And Installation Guide - Dantherm CDF 35 Service Manual

Mounting and installation guide

Suspension
NOTE
Condensate outlet The condensate outlet is located at the bottom of the dehumidifier. The unit has a drain
Placing of the
condensate outlet
Connection of
power supply
18
The wall suspension bar supplied with the unit is
fixed to the wall and the dehumidifier is hung up
on it. It is important to mount the unit in a
horizontal position to secure correct outflow of
the condensate water.
To make sure that the room air passes
unimpededly through the dehumidifier, air inlet
and air outlet openings must be free.
It is important that the dehumidifier is not
installed near a source of heat as for example a
radiator, and doors and windows must be kept
closed when the dehumidifier is in function
Dantherm Air Handling recommends a minimum distance between dehumidifier and
ceiling and dehumidifier and floor of 225 mm.
*)
The dimensions indicate the placing of the wall suspension bar.
spigot intended for connection of a ½'' flexible or fixed water connection. If water drain
through the wall is chosen, a suitable hole is made in the wall and the condensate hose
is led out through this hole, before suspending the dehumidifier on the wall suspension
bar.
It is important that the hose from the dehumidifier to the drainage has a fall of at least
2 % to make sure that the water runs away from the condensate tray.
As an alternative a condensate pump can be fitted at the water outlet to pump the
water to a drain.
The placing of the
condensate outlet is
shown on the drawing
– the unit is seen from
above.
Power is connected to the unit in accordance with the nameplate. Please refer to the
wiring diagrams from page 54.
Note! All electrical connections must be made in accordance with local power supply
company regulations.
*