Accessories - Dantherm Silencio 600 Service Manual

Accessories

This section will give you an overview of the available accessories for Silencio. You will
Introduction
find a list of accessories as well as a short description including part number for
ordering.
Additional information is available on each accessory, please contact Dantherm Air
Handling A/S.
Here is the complete list with drawing, description and part number for all available
List
accessories for Silencio:
Accessory
Alarm Cable
Filter guard
Illustration
Male SUB-D 25W connector and
25 free wires supplied with
terminal ends.
Wire No. 5 and wire No. 12 are
connected to each other through a
terminal block.
See more about the SUB-D-
signals in section "Description of
parts", page 11
Two male SUB-D 25W connector
mounted.
See more about the SUB-D-
signals in section "Description of
parts", page 11
One male SUB-D 25W connector
mounted and a connection box
with 23 terminals block.
See more about the SUB-D-
signals in section "Description of
parts", page 11
Comprises a pressure switch
control gauging the air pressure
before and after the filter. When
the filter gets dirty, the pressure
difference will go above the switch
setting and activate the alarm
lamp on "warning" level. This is to
indicate that if not replaced the
filter will clog with reduced cooling
capacity as a result.
Description
Continued overleaf
Part no.
016356
016359
016360
20-200:
013038
50-500:
014568
35