Set points
Introduction
General
Factory settings
How to change
Limitations
20
This section gives you information about the set points.
The following topics will be described:
• Factory settings
• How to change set points
This section describes how to change set points on a stand alone unit without any of
the accessories DanView or DanLink. Changing settings with DanView or DanLink
please refer to the manuals for these products.
The factory settings are as follows:
Set point
Heater
Active cooling
Using the dials on the front of the control board you are able to change the above
settings.
Limitations in set points: Please notice that the minimum difference between cooling
For further information about the set point settings, please see section "Users guide",
page 31.
Factory
5 °C
27 °C
and heating set point must be 10 degrees or more to avoid
fighting between active cooling and heating.
Range
0 °C to15 °C
20 °C to 40 °C