Description Of The Control Board - Dantherm Silencio 600 Service Manual

Description of the control board

Introduction
DanCon
Illustration
Part/function
14
This section gives you a detailed description of the control board and its test function.
Description of how to change settings is to find in section "Users guide", page 31.
All Silencios are provided with a DanCon control board.
This drawing illustrates the control board:
This table gives you a description of each part on the control board:
Part
LED
Test
Occupied
Dials
RS485 communication port
Locking mechanisms
Function
The LEDs show the status and the alarm
Learn more about the status and alarms in the
following
By pressing this button the unit will run
through a quick test program.
Any detected fail can be read on the fail LED
By pressing this bottom the unit will go into the
occupied function. Learn more about the
occupied/service function in section
"Functional description", page 17
These dials give you the possibility of
changing the heater and/or the cooling set
points, see more in the section "Set points",
page 20 and in the "Users guide", page 31
These ports give you the possibility of
connecting a pc and/or DanLink
telemonitoring program (accessory)
The locking mechanisms must be released to
remove the control panel. Remember to lock
the locking mechanisms whenever a control
board has been released.
Continued overleaf