Dantherm Silencio 600 Service Manual page 13

Description of parts,
The 25 poled SUB-D connection gives you the possibility of connecting additional
25 poled SUB-D,
external equipment (see table below).
connections
Furthermore you have the same functionality as the RS485 communication port, for
details about this, see section "Description of the control board", page 14.
Warning!
A male Sub-D 25 connector with a connection between 5 and 12 is mounted on the
female Sub-D 25 connector. A removal of this male Sub-D 25 connector during
operation will cause the unit to stop.
Sub-D 25 connections
The following explain the connections. The connector is shown from above:
Pin
no.
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
continued
Color
1 White/Blue Hotspot sensor
2 Blue/White Hotspot sensor
3 White/Orange Alarm
4 Orange/White Alarm
5 White/Green Smoke alarm
6 Green/White Warning
7 White/Brown Warning
8 Brown/White Fault
9 White/Gray Fault
Gray/White Interconnection +
Red/Blue Interconnection -
Blue/Red Smoke alarm
Red/Orange Occupied
Orange/Red Humidity sensor
Red/Green Not connected
Green/Red Analogue input 2
Red/Brown Analogue/Occupied/Humidity Common
Brown/Red Not connected
Red/Gray RS485A
Gray/Red RS485B
Black/Blue Not connected
Blue/Black Not connected
Black/Orange Not connected
Orange/Black Not connected
Black/Green Not connected
Description Function
Input
Input
Output
Output
Common
Output
Output
Output
Output
Input
Input
Input
Input
Input
-
Input
-
Output
Output
-
-
-
-
-
Default setting
-
-
Normally closed
Normally closed
-
Normally closed
Normally closed
Normally closed
Normally closed
-
-
Normally closed
Normally open
Normally open
-
-
-
-
-
-
-
-
-
-
-
13