Service Guide - Dantherm CDF 10 Service Manual

Service guide

Access to the Remove the front panel by unscrewing the two screws on the top of the dehumidifier.
control Lift the front panel vertically upwards and then pull it horizontally away from the unit.
The control of the unit is located in a box behind the front panel. To get access to the
control unscrew the 4 screws on the sides.
Maintenance The dehumidifier requires very little attention for trouble free running. All the necessary
safety and control functions have been built in. The fan motor and the compressor have
permanent lubrication and require no particular maintenance.
Cleaning of the
dehumidifier
Once a month the air inlet filter should be
checked and cleaned if necessary. The
front cover panel is removed and the filter
taken out. Clean the filter in tepid soapy
water or if not badly soiled by vacuum
cleaning
20
Once a month Once a year
Once a year the front cover panel should
be removed in order to check the inside of
the dehumidifier. If the dehumidifier is
dirty it should be cleaned by vacuum
cleaning. The condenser in particular
should be thoroughly vacuumed. If the
tube evaporator is badly soiled, it may be
washed in tepid soapy water