Mounting - Dantherm Silencio 600 Service Manual

Mounting

Introduction This section will guide you through mounting of the Silencio.
Warning Silencio is not designed to be transported after it has been mounted on the container,
and we strongly recommend not to mount the units until after the containers have been
finally placed on site.
If, in spite of these reservations, customers choose to mount the units on the containers
before these have been finally placed, Dantherm Air Handling cannot be held
responsible for whatever complications might arise.
Before you start Make sure you have the following available before you start mounting:
• 13 mm nut driver
• Useful tools to make the slot – dependent on the materials of the wall/shelter
Caution! You must be certain that the wall of the shelter can carry
the weight of the «Produktnavn_fx_VAM40_MK_II» unit.
Weight of the «Produktnavn_fx_VAM40_MK_II»: >
250 kg
If the wall is not strong enough you must reinforce the
wall!
NB: Minimum 300 mm distance between the unit
Procedure Follow these steps to mount the unit:
Step
bottom and the ground level, this due to the air
intake at the bottom of the unit
1 Mark up on the shelter according to
the measures on the drawings:
• where to cut the slot, see the
picture to the right
• where to mount the two wall
bracket and , see the below
picture
Action
Floor level
Continued overleaf
25