Mounting And Installation Instructions - Dantherm CDP 35T Service Manual

Mounting and installation instructions

Introduction This topic contains all necessary information to be able to mount the duct kit and the
dehumidifier correctly.
The electrical installation is described at the end of this section.
Measuring the Please follow this procedure to establish the ducts:
ducts
Step
Important The suggested minimum space between unit and ceiling and between unit and floor is
225 mm.
See the dimensional outlines on page 95.
Duct kit The Dantherm Air Handling duct kit is suitable for wall thicknesses from 70 to 350 mm
The duct kit in- The duct kit includes the parts shown below:
cludes ...
1 Cut out the stencil from the packaging and tape it onto the wall where you
want the unit to hang
2 Use the stencil to mark off the position of the ducts and the bar for suspen-
sion of the dehumidifier
You may also use the dimensional outlines on page 95 to make the mark-
ings
3 Establish the duct openings
4 Measure the depth of the ducts
5 Adjust and mount the ducts according to the Measuring in step 4, see also "
Mounting of the duct kit"
Action
Duct kit
Model
CDP 35T
CDP 45T
CDP 65T
C
434 mm
743 mm
1284 mm
Continued overleaf
25