Mounting And Installation - Dantherm HEX 30 Service Manual

Mounting and installation

This section will guide you through the mounting and installation of the HEX 30.
Introduction
• Only trained and certified technicians are allowed to replace parts
Caution!
• Switch of the DC supply before working on the unit
• Make sure that all work has been performed before switching on the power again
Make sure you have the following available before you start the installation:
Before you start
• 8 M6 nuts
• Cable with Sub-D 9 pole plug
Follow this procedure to mount the unit to the inside of the enclosure door:
Mounting
Step
1 Mount 8 M6 nuts on the mounting
door without fastening them
2 Mount a gasket between the HEX
30 and the door; this is the IP bar-
rier against the outdoor environ-
ment
3 Place the HEX 30 on the door and
fasten the nuts
4 Connect power (48 V DC) to the
unit
Action
11