Advertisement
Speed Calibration
All new systems require a ground
speed calibration to ensure
accurate area totals and accurate
ground speed readings. To complete the calibration,
measure a course 400 long preferably on level ground
with a start and finish point. The seeder must be in the
down position throughout this procedure.
SPEED CALIBRATION
1. Measure 400ft distance
2. Select "START CALIBRATION"
and begin driving.
3. Pulses will start accumulating below.
4. Select "EXIT AND SAVE" below to complete.
START
WHEEL PULSES RECEIVED
RADAR PULSES RECEIVED
NOTE
During the calibration the monitor is looking for the
number of pulses produced from the seeder mounted
sensor or in the case of radar, the number of radar pulses.
1. Select the "Start Calibration"
button to begin.
2. As you drive the 400ft.
distance, pulses for both Wheel Pulses and/or Radar
Pulses will begin accumulating on-screen.
3. When you've reached the end of the 400ft. distance,
select "EXIT & SAVE" to complete the calibration
procedure. Depending on which "Speed Source" is
selected, the monitor will store this value into either
the "Wheel Pulses Per 400" or "Radar Pulses Per
400" area.
Implement Switch
The implement switch is used to tell
the monitor if a Lift Sensor is being
used to determine when the
machine is raised or lowered. The Lift Sensor is used
when shaft rotation cannot be used or a variable rate drive
such as common on air seeders, is being used. The "Imp.
Switch" button toggles between "Disabled" or
"Enabled".
Set to "Disabled" for Brillion Landscape
Seeder.
When the Monitor learns a
"Lift Switch Sensor" toggle the
"Implement Switch" button to
"Enabled".
4-4
TABLE OF CONTENTS
SPEED
CALIBRATION
SPEED
CALIBRATION
0
:
0
:
BACK
EXIT & SAVE
SPEED
CALIBRATION
IMP. SWITCH:
DISABLED
IMP. SWITCH:
ENABLED
Implement Switch Setup
Implement Switch
Setup tells the
monitor if the
Implement Switch
IMP. SWITCH SETUP
Lift Sensor is
RAISED:
associated with the
OPEN
Implement Lift
CURRENT:
being raised or
LOWERED:
CLOSED
lowered.
The Implement
Switch Setup toggles between "Open" or "Closed".
Select icon "Set Highest" or "Set Lowest" to "Open"
the Implement Switch, the other will automatically
"Close".
Settings Menu -
Clutch Setting
The Landscape Seeder has a Clutch that is controlled by
the Brillion Elite Mini Monitor. The Clutch must be set.
CLUTCH SETTINGS
CLUTCH 1 DETAILS:
CLUTCH
SECTION
ENGAGE
WIDTH:
AT:
0V
PREV.
1. Set "Total Clutches" to 1 by pressing icon "-" or "+"
2. Set each "Clutch Details" as follows: to toggle
between each Clutch Detail press icon NEXT or
PREV.
•
Clutch engage at: 0 Volts
(Toggles between 0 and 12 Volts)
•
Section Width: 8.0 Feet, 10 Feet, or 12 Feet
Set to Model Width
3. Select "BACK" to get to the Setting Menu.
SWITCH
SETTINGS
BACK
SET HIGHEST
OPEN
SET LOWEST
CLUTCH
SETTINGS
BACK
TOTAL
CLUTCHES
1
8.0 FT
NEXT
9K998-2306
Advertisement
